【精品标准】AS NZS 12211997 Amdt 12003 Fire hose reels.doc

《【精品标准】AS NZS 12211997 Amdt 12003 Fire hose reels.doc》由会员分享，可在线阅读，更多相关《【精品标准】AS NZS 12211997 Amdt 12003 Fire hose reels.doc（4页珍藏版）》请在三一办公上搜索。

1、AS/NZS 1221:1997/Amdt 1/2003-01-23STANDARDS AUSTRALIA/STANDARDS NEW ZEALANDAmendment No. 1 toAS/NZS 1221:1997Fire hose reelsREVISED TEXTThe 1997 edition of AS/NZS 1221:1997 is amended as follows; the amendment(s) should be inserted in the appropriate place(s).SUMMARY:This Amendment applies to clause

2、s 2.3.1, 3.1, 4.3.1, 4.3.2, Table 2.1, Figure C1 andAppendix F.Published on 23 January 2003.Approved for publication in New Zealand on behalf of the Standards Council of New Zealand on 13 December 2002.AMDT No. 1JAN2003Page 9 Clause 2.3.1rdththDelete Item (a) and replace with the following:(a) Fixed

3、 hose reelsshall have not less than 100 mm clearance between the cabinet side walls and the hose reel. The clearance of the hose reel to the projected outline of the cabinet door opening shall be not less than 100 mm (see Figure 2.3)AMDT No. 1Page 10 Table 2.1, Column 3, 3 , 4and 5entriesJAN2003AMDT

4、 No. 1JAN2003AMDT No. 1JANBetween the words bore of and 19 and the words and and 25 insert the words notless than.Page 14 Clause 3.1, paragraph 1, lines 2 and 3Delete the words except that hose reels manufactured for use in New Zealand need not be100% pressure tested as long as they are marked in ac

5、cordance with Clause 4.3.1(f).Page 16 Clause 4.3.1 (Item f)Delete Item (f).2003 AMDT No. 1JAN2003Page 16 Clause 4.3.2Delete Clause 4.3.2.ISBN 0 7337 5009 5AMDT No. 1JAN2003Page 24 Figure C1Delete existing figure and replace with the following (In the caption for the weight the wordchanged has been corrected to read charged):FIGURE C1 DETAILS OF LOAD TEST FOR SWING ARM TYPE HOSE REELSAMDT No. 1JANPage 28 Appendix F, paragraph F4 (Item (a)In line 2, delete the word altitude and replace with the word attitude.2003 This page has been left intentionally blank.国内外标准大全豆丁网国内外标准下载地址