覆盖件模具库教程CATIA CAA V5 based.doc

《覆盖件模具库教程CATIA CAA V5 based.doc》由会员分享，可在线阅读，更多相关《覆盖件模具库教程CATIA CAA V5 based.doc（13页珍藏版）》请在三一办公上搜索。

1、CATIA CAA V5 basedGuideline: 3. Add DieContents1.OPEN “DIE123” FROM YOUR WORKING DIRECTORY22.RESULT IS DIE123 WITH PART DATA AND DRAW PRESS33.SELECT ADD CASTING = ASSEMBLED CASTINGS = DRAWDIE_I44.GO ON POSITION TAB FOR DIE POSITION55.GO ON INTEGRATION TAB “TOUT1+TOP” FOR INPUT DATA SELECTION66.GO ON

2、 INTEGRATION TAB “BINN1+BAS” FOR INPUT DATA SELECTION87.GO ON INTEGRATION TAB “BOUT1+BAS” FOR INPUT DATA SELECTION98.GO ON INTEGRATION TAB “POUT1+BAS” FOR INPUT DATA SELECTION119.USE CATIA LOCAL UPDATE WITH STOPWATCH1210.STORE ALL THE DOCUMENTS IN THE WORKING DIRECTORY.131. Open “Die123” from your w

3、orking directoryUse Catia File Open Select Die123.CATProduct“ from CATIA-Directory2. Result is Die123 with Part data and Draw press3. Select Add Casting = Assembled Castings = DrawDie_IConfirm with 4. Go on Position Tab for Die positionSelect for POUT+BAS position: “Die Axis” in “Tailgate car situat

4、ion for selection ” tree.5. Go on Integration Tab “TOUT1+TOP” for input data selectionSelect for TOUT1+TOP mounted on: “DieHolder1+TOP” in “DrawPress_I” treeOpen for surface and contour selection: ”Tailgate car situation for selection ”Select for TOUT1+TOP surfaces and contours 6. Go on Integration

5、Tab “BINN1+BAS” for input data selectionOpen for surface and contour selection: ”Tailgate car situation for selection ”Select for BINN1+BAS surfaces and contours 7. Go on Integration Tab “BOUT1+BAS” for input data selectionSelect for BOUT1+BAS mounted on: “AirPin1+BAS” in “DrawPress_I” treeOpen for

6、surface and contour selection: ”Tailgate car situation for selection ” Select for BOUT1+BAS surfaces and contours 8. Go on Integration Tab “POUT1+BAS” for input data selectionSelect for POUT1+BAS mounted on: “DieHolder1+BAS” in “DrawPress_I” treeConfirm with 9. Use CATIA Local Update with StopwatchS

7、elect “DIE123” and confirm with Put in no show following components:Tailgate / Heckklappe, TOP_DrawPress_I1+Die123,TOP1+Die12310. Store all the documents in the working directory.Use “Save Management” and save “Die123”Use “Propagate directory”Confirm with Result: all files are stored on the working directoryThe EndT-Systems Enterprise Services GmbH Page 13 of 1313.06.2023