注塑模具DFM报告模板课件.ppt
《注塑模具DFM报告模板课件.ppt》由会员分享,可在线阅读,更多相关《注塑模具DFM报告模板课件.ppt(19页珍藏版)》请在三一办公上搜索。
1、Parts Analysis Report,“Engineering global parts”,Project No.:10CE697.3,Part Name.: housing,产品名,项目号,cavity,core,ACTUATOR HAND,PL,Banana gate will be in here,shrinkage rate correct?Kindly advise,Visible area _确认外观面,Is this part a visible one? If so kindly advise the where the visible area .,表达运水,表达流道,
2、表达放大图位置,Section G-G,基本直线,基本箭头,表达各种尺寸,表达截面,一些有用的图形,基本文本框,A,A,please advise,表达运水,表达流道,基本直线,基本文本框,please advise,鼠标在直线上点击右键,再点击设置为默认线条,设置好后就可以画出与这条线一样的线条啦!PS:设置好默认线条后,默认箭头会自动设置好!,同理,文本框与运水,流道也可以右键设置默认来方便画,Layout _模具排位,表达运水,表达流道,Slide,行位,斜顶,lifter,Inserts split line _镶件线确认,Insert here, OK?这里做镶件,OK?,Inser
3、t split line in red, OK?红色镶件线,请确认,Ejection _产品顶出确认,Ejector blade,Ejector sleeves,Ejector pins,lifter,Inner slide,Surface finish_产品抛光/晒纹位置确认,Is this part a visible one? If so please advise the which the visible area is and the surface finish spec.,MT11010 texture for red surface, please confirm.红色面晒M
4、T1101纹,请确认,Other surface apply Sandpaper 600# for mold release., please confirm.其它面省到600#砂纸出模,请确认,Draft Study _产品斜度分析,Green surfaces without draft angle now, suggest to enlarge to 1 degree at least (by reduce material) Kindly advise.绿色面直身,建议最小减胶加1度斜度,请确认.,Draft angle of the shut off surfaces (red ma
5、rked) is not enough , least (by reduce material) it should be 3 degree at least.图示红色面擦穿,斜度不足(单边最小3度),the red surface is straight, suggest add 3 draft angle on it (by reduce material) for texture MT0000, least (by reduce material), pls confirm. 红色直身面,建议减胶加3度出模角来晒纹MT0000,请确认.,Wall thickness study _产品壁



- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- 注塑 模具 DFM 报告 模板 课件

链接地址:https://www.31ppt.com/p-1557133.html