SGS灯具结构检查标准简介课件.ppt
《SGS灯具结构检查标准简介课件.ppt》由会员分享,可在线阅读,更多相关《SGS灯具结构检查标准简介课件.ppt(60页珍藏版)》请在三一办公上搜索。
1、Construction Check灯具 结构检查,Construction Check灯具 结构检查,EN 60598-2-1 固定式灯具EN 60598-2-2 嵌入式灯具EN 60598-2-3 道路和街道照明灯具EN 60598-2-4 可移式通用灯具EN 60598-2-5 泛光灯EN 60598-2-6 内装变压器的钨丝灯灯具EN 60598-2-7庭院用可移式灯EN 60598-2-8 手持式灯具EN 60598-2-10儿童用可移式灯具EN 60598-2-11 水族馆灯EN 60598-2-12 小夜灯EN 60598-2-13 地埋式灯 EN 60598-2-17 舞台灯光
2、、电视、电影及摄影场所(室内外)用灯具EN 60598-2-20 灯串,灯具 结构检查,常用测试标准,EN 60598-2-1 固定式灯具,IEC/ EN 61347-1: 灯控制器通用要求IEC/ EN 61347-2-2: 灯用电子变压器的特别要求IEC/ EN 61347-2-3: 荧光灯用电子镇流器的特别要求IEC/ EN 61347-2-8: 荧光灯用电感镇流器的特别要求IEC/ EN 61347-2-11: 杂类灯用电子线路(如灯串控制器)的特别要求IEC/ EN 61347-2-13: LED发光二极管驱动器的特别要求IEC/ EN 60570:灯用轨道系统(用于轨道灯)IEC/
3、 EN 61058-1: 灯用内置式机械/电子开关,电子调光器IEC/ EN 61058-2-1: 灯用线上机械/电子开关,电子调光器IEC/EN 61558: 变压器IEC/EN 60238, 61184, 60838: 灯座IEC/EN 60432: 灯泡IEC/EN 60083: 插头IEC/EN 60227, 60245:软线,灯具 结构检查,配件常用测试标准,IEC/ EN 61347-1: 灯控制器通用要,IEC/EN 60598-2-4. Portable general purpose luminaires.(可移式灯具,台灯、落地灯),IEC/EN 60598-2-5 Flo
4、odlights(投光灯),Example,灯具 结构检查,IEC/EN 60598-2-4. IEC/EN 60598,IEC/EN 60598-2-2. Recessed luminaires.(嵌入式灯具),IEC/EN 60598-2-7 Portable luminaires for garden use.(庭院灯)太阳能灯也适用该标准,灯具 结构检查,IEC/EN 60598-2-2. Recessed lum,IEC/EN60598-2-1. Fixed general purpose luminaires(固定式灯具,指吸顶灯、壁灯、天花灯),灯具 结构检查,IEC/EN605
5、98-2-1. Fixed general,IEC/EN 60598-2-3. Luminaires for road and street lighting. (路灯和街灯),灯具 结构检查,IEC/EN 60598-2-3. Luminaires f,IEC/EN 60598-2-18. Luminaires for swimming-pools and similar applications.(游泳池和类似场所用灯具),灯具 结构检查,IEC/EN 60598-2-18. Luminaires,IEC/EN 60598-2-20 Lighting chains(灯串),灯具 结构检查,
6、IEC/EN 60598-2-20 Lighting cha,IEC/EN 60598-2-1 fixed luminaires 也适用固定式的轨道灯轨道要用 EN 60570(Electrical supply track systems for luminaires ),灯具 结构检查,IEC/EN 60598-2-1 fixed luminai,Clause 0-8, 11 Section 0 Componet 元器件 Section 3 Marking 铭牌和说明书 Section 4 Construction 结构 Section 5 External and internal wi
7、ring 外部线和内部线 Section 7 Provision for earthing 接地防护 Section 8 Protection against electric shock 防触电 Section 11 Creepage distance and clearance 爬电距离和电气间隙,Clauses,灯具 结构检查,Clause 0-8, 11Clauses灯具 结构检查,IEC/EN 60598-1 Clause 0,5a. Components, other than integral components, shall comply with the requireme
8、nts of the relevant IEC standards, if any.b. Components which comply with the requirements of the relevant IEC standard and are marked with individual ratings are checked to establish that they suit the conditions which may occur in use. Aspects of use not covered by the respective standard shall re
9、quire them to satisfy the additional relevant requirements of this standard.c. Integral components shall comply as far as is reasonable with the IEC component standards,as part of the luminaire.NOTE 1 This does not imply that components need to be separately tested before approval of the luminaire.N
10、OTE 2 Guidance for selection of components in different kinds of luminaires can be found in Annex L.d. Internal wiring of a luminaire shall comply with the requirements in 5.3. NOTE 3 This does not exclude the use of standardized cables.,Section 0 Componet,灯具 结构检查,IEC/EN 60598-1 Clause 0,5Sect,e. Co
11、mponents complying with the requirements of their own standard and used inaccordance with their intended use, shall only be tested to the requirements of this standard where there are no requirements in the component standard (covering the requirement heading of this standard).NOTE A valid test repo
12、rt should be considered adequate to show compliance.Lampholders and starterholders shall additionally comply with the gauging and interchangeability requirements of the appropriate IEC component standard where applicable after building into the luminaire.For terminal blocks with an integrated screwl
13、ess earthing contact for direct connection to the luminaire or to parts of the body, special requirements apply according to Annex V.f. Components for which no appropriate IEC standard exists shall satisfy the relevantrequirements of this luminaire standard as part of the luminaire. Lampholders ands
14、tarterholders shall additionally comply with the gauging and interchangeability requirements of the appropriate IEC component standard where applicable.NOTE Examples of components are lampholders, switches, transformers, ballasts, flexible cables and cords and plugs.,Section 0 Componet,灯具 结构检查,e. Co
15、mponents complying with t,Section 0 Componet,灯具 结构检查,Section 0 Componet灯具 结构检查,IEC/EN 60598-1 Clause 3 markingThe following information shall be distinctly and durably marked on the luminaire (seeTable 3.1).a) Marking to be observed when replacing lamps or other replaceable components, shall be visi
16、ble on the outside of the luminaire (except the mounting side) or behind a cover which is removed during lamp or other component replacement and with the lamp removed.b) Marking to be observed during installation shall be visible during installation on the outside of the luminaire or behind a cover
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- SGS 灯具 结构 检查 标准 简介 课件
![提示](https://www.31ppt.com/images/bang_tan.gif)
链接地址:https://www.31ppt.com/p-1288372.html